FD60 fire doors: our service in Prescot
We provide FD60 fire doors in Prescot (L34 and the surrounding postcodes), from the first survey through to a documented handover.
Buildings in and around Prescot range from houses with integral garages to family homes after loft conversions and small offices. Whatever the building, the standard is the same: certified products, correct gaps, seals and closers, and a frame sealed to the wall.
FD60 openings in Prescot buildings tend to be stair cores, plant rooms and bin stores in larger blocks and commercial premises. For FD60 work in Prescot we generally fit certified doorsets, so frame and leaf share the same test evidence.
What do you hand over at the end?
For every FD60 opening we record the product and certificate reference, the gap measurements, the hinge and closer specification, how the frame was fixed and what was used to seal the frame-to-structure gap, with photographs before the architraves go on. That record is what your fire risk assessor or building control officer will ask for.
On a typical job that means:
- Intumescent and smoke seals as specified
- Check of the fire strategy rating for each opening
- Load-rated hinges and correctly powered closer
- 60-minute glazing systems where vision panels are needed
Fire door law for Prescot properties
Fire doors in Prescot fall under English rules. New and replacement doors are covered by the Building Regulations 2010 and Approved Document B. In workplaces and the common parts of blocks, the Regulatory Reform (Fire Safety) Order 2005, as clarified by the Fire Safety Act 2021, puts the duty on the responsible person to keep fire doors suitable and maintained.
For residential buildings in Prescot above 11 metres, regulation 10 of the Fire Safety (England) Regulations 2022 adds checks: communal fire doors at least every three months and best-endeavours checks of flat entrance doors at least every twelve months. Higher-risk buildings of at least 18 metres or seven storeys also come under the Building Safety Act 2022, where works may need approval from the Building Safety Regulator.
Who needs FD60 fire doors in Prescot?
The need for FD60 fire doors usually arises in refuse stores or mixed-use commercial buildings, and sometimes plant and boiler rooms. Each has its own pressures, such as residents at home or a building that must stay open, so we plan the sequence of work in Prescot to keep escape routes protected throughout.
What happens after you enquire
- Confirm the 60-minute requirement against the fire strategy
- Survey structure, opening size and wall type
- Order the certified doorset with ironmongery to its evidence
- Install the frame, fix and seal it to the structure
- Hang, adjust and test the leaf, closer and latching
- Record evidence and make good
Guide prices in Prescot
As a guide, budget £850–£1,800 per FD60 doorset supplied and fitted, ex VAT for FD60 fire doors. The figure for your Prescot building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.
Around Prescot
Prescot is about 12.0 km from Liverpool, and we cover both, along with nearby Huyton and St Helens. Send us your postcode and we'll confirm survey dates.
Questions
Is Prescot within your coverage area?
It is. We cover Prescot in Merseyside and neighbouring towns such as Huyton. There is no charge for the survey.
Do I need to be there for the survey?
Someone needs to give us access to the doors. For blocks and commercial buildings, a caretaker or site contact is fine; for HMOs and homes, we agree a time with you or your tenants.
Is FD60 just a thicker FD30?
No. FD60 doors are built and tested as a different product, usually with a thicker core, different seals and different ironmongery. Only the tested combination carries the 60-minute rating.
Do FD60 doors need smoke seals?
If the fire strategy asks for smoke control, yes: the door will be specified as FD60S or E60Sa with smoke seals. Many plant room doors are FD60 without a smoke requirement.