FD60 fire doors in Lincolnshire, done to the evidence
For FD60 fire doors anywhere in Lincolnshire, one team handles the survey, supply, installation and handover, covering Lincoln, Grimsby, Scunthorpe and the rest of the county.
Before ordering FD60 doors for a Lincolnshire building, we check the rating each opening actually needs, because over-specifying makes doors heavier and dearer. FD60 openings in Lincolnshire buildings tend to be stair cores, plant rooms and bin stores in larger blocks and commercial premises.
Wherever your building is in Lincolnshire, the fire safety duties come from national rules, and our installation standard is the same.
Why FD60 installation is less forgiving
A 54mm leaf can weigh considerably more than a 44mm one. That weight drives everything else: more robust frames and fixings, hinges rated for the load, and a closer with enough power to close and latch the door without making it too heavy to open. Glazing, if any, must use a 60-minute glass and glazing system from the same test evidence.
Because of this, most FD60 openings are best done as a certified doorset, so the frame and leaf come with matching evidence.
Which fire door rules apply in Lincolnshire?
In Lincolnshire, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.
Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Lincolnshire building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.
Our process in Lincolnshire
- Confirm the 60-minute requirement against the fire strategy
- Survey structure, opening size and wall type
- Order the certified doorset with ironmongery to its evidence
- Install the frame, fix and seal it to the structure
- Hang, adjust and test the leaf, closer and latching
- Record evidence and make good
What does FD60 fire doors cost in Lincolnshire?
As a guide, budget £850–£1,800 per FD60 doorset supplied and fitted, ex VAT for FD60 fire doors. The figure for your Lincolnshire building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.
FD60 fire doors questions
Do you provide FD60 fire doors across Lincolnshire?
Yes. We cover all of Lincolnshire, including Lincoln and Grimsby. Surveys and written quotes are free.
Is FD60 just a thicker FD30?
No. FD60 doors are built and tested as a different product, usually with a thicker core, different seals and different ironmongery. Only the tested combination carries the 60-minute rating.
Can I upgrade an FD30 door to FD60?
Not by adding parts. An FD30 leaf cannot be turned into an FD60 door with extra strips or paint. If an opening needs 60 minutes, the leaf, and usually the frame, need to be replaced with a certified FD60 product.