FD60 fire doors in Oadby

Getting FD60 fire doors right in Oadby

Our FD60 fire doors service in Oadby is simple: a survey, a fixed quote, certified products and an installation finished to the manufacturer's evidence.

Buildings in and around Oadby range from houses with integral garages to light industrial buildings and care homes. Whatever the building, the standard is the same: certified products, correct gaps, seals and closers, and a frame sealed to the wall.

FD60 openings in Oadby buildings tend to be stair cores, plant rooms and bin stores in larger blocks and commercial premises. Before ordering FD60 doors for a Oadby building, we check the rating each opening actually needs, because over-specifying makes doors heavier and dearer.

When does a building need FD60 rather than FD30?

FD60 doors appear where the fire strategy asks a wall to resist fire for an hour: stair cores and lobbies in taller buildings, plant and boiler rooms, some service risers, refuse stores and compartment walls between different uses. The rating follows the wall. Fitting an FD30 door in a 60-minute wall leaves a weak point, and fitting FD60 everywhere wastes money and makes doors harder to open.

We work from your fire strategy, the building's drawings or the fire risk assessment. Where these disagree with what is on site, we flag it before ordering.

What you get:

• Frame fixing and structural gap sealing recorded with photos
• Check of the fire strategy rating for each opening
• Intumescent and smoke seals as specified
• Certified FD60 doorset or leaf with matching evidence

What the rules say for Oadby

In Oadby, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.

Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Oadby building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.

Which buildings in Oadby need FD60 fire doors?

Typical settings for FD60 fire doors include stair cores in taller blocks, refuse stores and plant and boiler rooms. In Oadby, as anywhere, the duty holder varies: a responsible person for a workplace, a landlord or managing agent for a block or HMO, or a homeowner after building work. We adjust access, timing and paperwork to suit whoever commissions the work.

From enquiry to handover in Oadby

1. Confirm the 60-minute requirement against the fire strategy
2. Survey structure, opening size and wall type
3. Order the certified doorset with ironmongery to its evidence
4. Install the frame, fix and seal it to the structure
5. Hang, adjust and test the leaf, closer and latching
6. Record evidence and make good

Prices for FD60 fire doors in Oadby

Guide pricing for FD60 fire doors: £850–£1,800 per FD60 doorset supplied and fitted, ex VAT. Volume work across several doors in one Oadby building usually brings the per-door cost down. Your written quote is fixed once we have surveyed.

Around Oadby

We also cover towns near Oadby, including Wigston (2.8 km away), Leicester and Market Harborough. If your building is in LE2 or a neighbouring district, the service and pricing are the same.

Questions