Getting FD60 fire doors right in Dumfries & Galloway
Our FD60 fire doors service covers all of Dumfries & Galloway, across postcode districts including DG1, DG16 and DG8.
For FD60 work in Dumfries & Galloway we generally fit certified doorsets, so frame and leaf share the same test evidence. FD60 openings in Dumfries & Galloway buildings tend to be stair cores, plant rooms and bin stores in larger blocks and commercial premises.
Managing agents, landlords, schools, care providers, businesses and homeowners in Dumfries & Galloway can all use one team for survey, supply, installation and evidence. We plan work around occupants and hand over a record for every door.
When does a building need FD60 rather than FD30?
FD60 doors appear where the fire strategy asks a wall to resist fire for an hour: stair cores and lobbies in taller buildings, plant and boiler rooms, some service risers, refuse stores and compartment walls between different uses. The rating follows the wall. Fitting an FD30 door in a 60-minute wall leaves a weak point, and fitting FD60 everywhere wastes money and makes doors harder to open.
We work from your fire strategy, the building's drawings or the fire risk assessment. Where these disagree with what is on site, we flag it before ordering.
What the rules say for Dumfries & Galloway
Dumfries & Galloway is in Scotland, which has its own system. Building work, including many fire door replacements, is governed by the Building (Scotland) Regulations 2004 and the Technical Handbooks, with Section 2 covering fire; where a building warrant is needed it comes from the local authority. In non-domestic premises, the Fire (Scotland) Act 2005 and the Fire Safety (Scotland) Regulations 2006 set the duties.
The common parts of private blocks of flats largely sit outside Part 3 of the 2005 Act, so the fire risk assessment and housing obligations usually drive fire door work in residential buildings in Dumfries & Galloway.
The steps on a Dumfries & Galloway installation
- Confirm the 60-minute requirement against the fire strategy
- Survey structure, opening size and wall type
- Order the certified doorset with ironmongery to its evidence
- Install the frame, fix and seal it to the structure
- Hang, adjust and test the leaf, closer and latching
- Record evidence and make good
What does FD60 fire doors cost in Dumfries & Galloway?
As a guide, budget £850–£1,800 per FD60 doorset supplied and fitted, ex VAT for FD60 fire doors. The figure for your Dumfries & Galloway building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.
Questions
Do you provide FD60 fire doors across Dumfries & Galloway?
Yes. We cover all of Dumfries & Galloway. Surveys and written quotes are free.
Is FD60 just a thicker FD30?
No. FD60 doors are built and tested as a different product, usually with a thicker core, different seals and different ironmongery. Only the tested combination carries the 60-minute rating.
Can I upgrade an FD30 door to FD60?
Not by adding parts. An FD30 leaf cannot be turned into an FD60 door with extra strips or paint. If an opening needs 60 minutes, the leaf, and usually the frame, need to be replaced with a certified FD60 product.