FD60 fire doors: our service in Rhyl
From the LL18 postcode district outwards, we take on FD60 fire doors across Rhyl for homes, blocks and workplaces.
Buildings in and around Rhyl range from family homes after loft conversions to small blocks of flats and houses with integral garages. Whatever the building, the standard is the same: certified products, correct gaps, seals and closers, and a frame sealed to the wall.
FD60 openings in Rhyl buildings tend to be stair cores, plant rooms and bin stores in larger blocks and commercial premises. Before ordering FD60 doors for a Rhyl building, we check the rating each opening actually needs, because over-specifying makes doors heavier and dearer.
What do you hand over at the end?
For every FD60 opening we record the product and certificate reference, the gap measurements, the hinge and closer specification, how the frame was fixed and what was used to seal the frame-to-structure gap, with photographs before the architraves go on. That record is what your fire risk assessor or building control officer will ask for.
Each installation includes:
- Intumescent and smoke seals as specified
- Certified FD60 doorset or leaf with matching evidence
- Frame fixing and structural gap sealing recorded with photos
- 60-minute glazing systems where vision panels are needed
Fire door law for Rhyl properties
Rhyl is in Wales, where new and replacement fire doors are covered by the Building Regulations 2010 as applied in Wales, with the Welsh Approved Document B as guidance. The Regulatory Reform (Fire Safety) Order 2005 also applies, so responsible persons in workplaces and the common parts of blocks must keep fire doors maintained.
One difference from England: regulation 10 of the Fire Safety (England) Regulations 2022, with its quarterly and annual fire door checks, does not apply in Wales. Your fire risk assessment sets the checking regime instead, and we work to it.
Where FD60 fire doors fit in Rhyl
Typical settings for FD60 fire doors include refuse stores, stair cores in taller blocks and plant and boiler rooms. In Rhyl, as anywhere, the duty holder varies: a responsible person for a workplace, a landlord or managing agent for a block or HMO, or a homeowner after building work. We adjust access, timing and paperwork to suit whoever commissions the work.
How a Rhyl job runs
- Confirm the 60-minute requirement against the fire strategy
- Survey structure, opening size and wall type
- Order the certified doorset with ironmongery to its evidence
- Install the frame, fix and seal it to the structure
- Hang, adjust and test the leaf, closer and latching
- Record evidence and make good
Guide prices in Rhyl
As a guide, budget £850–£1,800 per FD60 doorset supplied and fitted, ex VAT for FD60 fire doors. The figure for your Rhyl building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.
Around Rhyl
Neighbouring towns such as Colwyn Bay, Flint, Heswall and Wallasey are covered too, so clients with several buildings can use one installer and one evidence format.
Questions
Is Rhyl within your coverage area?
It is. We cover Rhyl in Clwyd and neighbouring towns such as Colwyn Bay. There is no charge for the survey.
What happens on a survey in Rhyl?
We look at every door in scope: the leaf, frame, gaps, seals, hinges, closer, glazing and how the frame is fixed. You then get a written quote that prices each door separately.
Are FD60 doors harder to open?
They are heavier, so the closer has to be chosen and adjusted with care. A well-set closer will still close and latch the door while keeping the opening force reasonable for the people who use it.
Can I upgrade an FD30 door to FD60?
Not by adding parts. An FD30 leaf cannot be turned into an FD60 door with extra strips or paint. If an opening needs 60 minutes, the leaf, and usually the frame, need to be replaced with a certified FD60 product.