Getting FD60 fire doors right in Ampthill
If you need FD60 fire doors in Ampthill, we can survey, supply and install, then leave you the evidence your fire risk assessor will ask for.
Ampthill has a broad mix of buildings, including care homes, family homes after loft conversions and small offices, and the same fire door principles apply to all of them.
For FD60 work in Ampthill we generally fit certified doorsets, so frame and leaf share the same test evidence. FD60 openings in Ampthill buildings tend to be stair cores, plant rooms and bin stores in larger blocks and commercial premises.
What do you hand over at the end?
For every FD60 opening we record the product and certificate reference, the gap measurements, the hinge and closer specification, how the frame was fixed and what was used to seal the frame-to-structure gap, with photographs before the architraves go on. That record is what your fire risk assessor or building control officer will ask for.
What you get:
- Certified FD60 doorset or leaf with matching evidence
- Frame fixing and structural gap sealing recorded with photos
- Check of the fire strategy rating for each opening
- Load-rated hinges and correctly powered closer
Which fire door rules apply in Ampthill?
The rules that apply to fire doors in Ampthill are England's. The responsible person under the Regulatory Reform (Fire Safety) Order 2005 must keep fire doors in non-domestic premises and the common parts of flats in working order; the Fire Safety Act 2021 confirmed that this includes flat entrance doors onto common parts.
Where a Ampthill block is above 11 metres, regulation 10 of the 2022 regulations means communal doors are checked every three months and flat entrance doors annually on a best-endeavours basis. Replacement doors must also satisfy the Building Regulations, with Approved Document B as the guidance most building control bodies work from.
Where FD60 fire doors fit in Ampthill
You are most likely to need FD60 fire doors if you look after stair cores in taller blocks, plant and boiler rooms or refuse stores. Whatever the building in Ampthill, we survey each opening and tell you which doors need work and which do not.
What happens after you enquire
- Confirm the 60-minute requirement against the fire strategy
- Survey structure, opening size and wall type
- Order the certified doorset with ironmongery to its evidence
- Install the frame, fix and seal it to the structure
- Hang, adjust and test the leaf, closer and latching
- Record evidence and make good
Guide prices in Ampthill
As a guide, budget £850–£1,800 per FD60 doorset supplied and fitted, ex VAT for FD60 fire doors. The figure for your Ampthill building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.
Nearby areas we cover from Ampthill
Ampthill is about 17.2 km from Luton, and we cover both, along with nearby Bedford and Dunstable. Send us your postcode and we'll confirm survey dates.
Questions
Is Ampthill within your coverage area?
It is. We cover Ampthill in Bedfordshire and neighbouring towns such as Bedford. There is no charge for the survey.
What happens on a survey in Ampthill?
We look at every door in scope: the leaf, frame, gaps, seals, hinges, closer, glazing and how the frame is fixed. You then get a written quote that prices each door separately.
Are FD60 doors harder to open?
They are heavier, so the closer has to be chosen and adjusted with care. A well-set closer will still close and latch the door while keeping the opening force reasonable for the people who use it.
Is FD60 just a thicker FD30?
No. FD60 doors are built and tested as a different product, usually with a thicker core, different seals and different ironmongery. Only the tested combination carries the 60-minute rating.