FD30 fire doors in Sheffield

FD30 fire doors: our service in Sheffield

For property owners, landlords and managing agents in Sheffield, we offer FD30 fire doors with one team for the survey, the product and the installation.

Buildings in and around Sheffield range from mixed-use office buildings to shared houses and converted flats. Whatever the building, the standard is the same: certified products, correct gaps, seals and closers, and a frame sealed to the wall.

In Sheffield, FD30 doors are the usual choice for escape-route corridors, stairs and kitchen doors where the fire strategy asks for 30 minutes. Each FD30 leaf we supply for Sheffield is sized for the opening, rather than trimmed beyond what its certification allows.

What does a correct FD30 installation include?

A typical timber FD30 leaf is around 44mm thick and hangs on at least three fire-tested hinges. The gaps between leaf and frame are set to the manufacturer's data, usually around 3mm. Intumescent strips, and smoke seals where needed, go in the frame or leaf edge as specified. The closer must pull the door shut and latch it from any angle. Every hole cut for a lock, latch or hinge is lined with intumescent material where the certification calls for it.

Then comes the part that is often skipped: sealing the gap between the frame and the wall with a tested material, as BS 8214:2026 now sets out in more detail.

What you get:

• Photo record, product data and certificate references at handover
• Certified FD30 or FD30S leaf, or full doorset
• Survey of the opening, frame and existing ironmongery
• Intumescent strips and smoke seals to the certification

The regulations behind fire doors in Sheffield

Fire doors in Sheffield fall under English rules. New and replacement doors are covered by the Building Regulations 2010 and Approved Document B. In workplaces and the common parts of blocks, the Regulatory Reform (Fire Safety) Order 2005, as clarified by the Fire Safety Act 2021, puts the duty on the responsible person to keep fire doors suitable and maintained.

For residential buildings in Sheffield above 11 metres, regulation 10 of the Fire Safety (England) Regulations 2022 adds checks: communal fire doors at least every three months and best-endeavours checks of flat entrance doors at least every twelve months. Higher-risk buildings of at least 18 metres or seven storeys also come under the Building Safety Act 2022, where works may need approval from the Building Safety Regulator.

Where FD30 fire doors fit in Sheffield

From shops to care homes, the requirement for FD30 fire doors in Sheffield comes from the fire strategy or risk assessment for the building. We work from that document, or help you interpret your inspection report, before quoting.

How a Sheffield job runs

1. Measure the opening, check the frame and confirm the rating needed
2. Order a certified leaf or doorset to size, with matching components
3. Remove the old door and assess the frame or structural opening
4. Fix the frame and hang the leaf to the certified gap tolerances
5. Fit seals, hinges, latch, closer and signage, then test close-and-latch
6. Seal the frame-to-wall gap, make good and record the evidence

Guide prices in Sheffield

If you need a budget figure first, the guide for FD30 fire doors is £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT. We firm that up after a survey, pricing each door separately so you can see where the money goes.

Around Sheffield

As well as Sheffield, we cover neighbouring towns including Burngreave, Rotherham and Dronfield. The survey and quote are free.

Questions from Sheffield