Double fire doors in Oadby, done to the evidence
We provide double fire doors in Oadby (LE2 and the surrounding postcodes), from the first survey through to a documented handover.
Buildings in and around Oadby range from light industrial buildings to small offices and schools. Whatever the building, the standard is the same: certified products, correct gaps, seals and closers, and a frame sealed to the wall.
Double doors on wards, school corridors and lobbies in Oadby take heavy use, so closing sequence and meeting-edge seals get extra attention. Every pair we fit in Oadby is commissioned so both leaves close in the right order and latch.
Why pairs need extra care
The meeting stiles are the weak point of a pair. Gaps there must be controlled, both leaves need intumescent and smoke seals as specified, and if the meeting edges are rebated, a door coordinator is usually needed so the leaves close in the right order. If they close out of sequence, the door may not latch and will not perform as tested.
On a typical job that means:
- Closers matched to each leaf
- Meeting-stile intumescent and smoke seals
- Flush bolts and hold-opens within evidence
- Equal pair or leaf-and-a-half doorsets
Which fire door rules apply in Oadby?
In Oadby, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.
Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Oadby building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.
Buildings and duty holders in Oadby
Typical settings for double fire doors include office cores, care homes and hospitals and clinics. In Oadby, as anywhere, the duty holder varies: a responsible person for a workplace, a landlord or managing agent for a block or HMO, or a homeowner after building work. We adjust access, timing and paperwork to suit whoever commissions the work.
The steps on a Oadby installation
- Survey opening width, use and traffic
- Select pair configuration and hardware set
- Order certified doorset with coordinator and bolts if needed
- Install frame and hang both leaves
- Set closing sequence, seals and latching
- Test hold-open release and record evidence
Budgeting for double fire doors in Oadby
Guide pricing for double fire doors: £1,600–£3,400 per pair supplied and fitted, depending on glazing and hardware, ex VAT. Volume work across several doors in one Oadby building usually brings the per-door cost down. Your written quote is fixed once we have surveyed.
Nearby areas we cover from Oadby
We also cover towns near Oadby, including Wigston (2.8 km away), Leicester and Market Harborough. If your building is in LE2 or a neighbouring district, the service and pricing are the same.
Questions
Is Oadby within your coverage area?
It is. We cover Oadby in Leicestershire and neighbouring towns such as Wigston. There is no charge for the survey.
What happens on a survey in Oadby?
We look at every door in scope: the leaf, frame, gaps, seals, hinges, closer, glazing and how the frame is fixed. You then get a written quote that prices each door separately.
Why does the gap between the two leaves matter?
The meeting edges are where flame and smoke can pass most easily. The gap and the seals there must match the certification for the pair to perform as tested.
Do both leaves need closers?
Usually, yes. Each leaf of a fire door pair needs to close itself. The closers are sized to each leaf's width and weight.