Intumescent strips and smoke seals in Wallsend: what's involved
If you need intumescent strips and smoke seals in Wallsend, we can survey, supply and install, then leave you the evidence your fire risk assessor will ask for.
Wallsend has a broad mix of buildings, including schools, care homes and family homes after loft conversions, and the same fire door principles apply to all of them.
We check that each door in your Wallsend building closes and latches against its new seals before signing it off. Painted and missing seals are among the most common fire door defects nationally; in Wallsend we replace them with the type and size the certification specifies.
Pads, linings and hidden protection
Fire doors also rely on intumescent material you cannot see: pads behind hinges, linings around lock bodies and glazing seals. Where these are missing or damaged, we fit the correct items as part of the work.
Each installation includes:
- Intumescent strips in frame or leaf edge
- Intumescent pads to hinges and locks
- Brush or blade smoke seals
- Removal of damaged or painted seals
Fire door law for Wallsend properties
In Wallsend, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.
Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Wallsend building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.
Which buildings in Wallsend need intumescent strips and smoke seals?
From blocks of flats to care homes, the requirement for intumescent strips and smoke seals in Wallsend comes from the fire strategy or risk assessment for the building. We work from that document, or help you interpret your inspection report, before quoting.
Our process in Wallsend
- Identify door certification and seal specification
- Remove failed seals and clean the grooves
- Fit new strips and seals to the specified positions
- Fit missing pads and lock linings
- Check the door closes and latches against the new seals
- Record the products fitted
What does intumescent strips and smoke seals cost in Wallsend?
If you need a budget figure first, the guide for intumescent strips and smoke seals is £45–£110 per door to supply and fit strips and seals, ex VAT. We firm that up after a survey, pricing each door separately so you can see where the money goes.
Wallsend and neighbouring towns
Wallsend is about 5.5 km from Newcastle upon Tyne, and we cover both, along with nearby Hebburn and Jarrow. Send us your postcode and we'll confirm survey dates.
Common questions
Do you work in Wallsend?
Yes, we take on intumescent strips and smoke seals in Wallsend and the surrounding area, including Hebburn and Jarrow. Send your postcode and a few details and we'll come back with survey dates.
Do I need to be there for the survey?
Someone needs to give us access to the doors. For blocks and commercial buildings, a caretaker or site contact is fine; for HMOs and homes, we agree a time with you or your tenants.
Can I just add intumescent strips to an ordinary door?
No. Strips do not turn an ordinary door into a fire door. They only work as part of a door that was tested and certified with them.
Do all fire doors need smoke seals?
Only where the door is specified for smoke control, such as FD30S doors. Many doors on escape routes and flat entrances are specified this way.