Intumescent strips and smoke seals in Sandown, done to the evidence
Our intumescent strips and smoke seals service in Sandown is simple: a survey, a fixed quote, certified products and an installation finished to the manufacturer's evidence.
Sandown has a broad mix of buildings, including small offices, houses with integral garages and care homes, and the same fire door principles apply to all of them.
Painted and missing seals are among the most common fire door defects nationally; in Sandown we replace them with the type and size the certification specifies. We check that each door in your Sandown building closes and latches against its new seals before signing it off.
Getting the specification right
The door's certification states the type, size and position of strips and seals: in the frame or the leaf edge, single or double, and whether a combined intumescent and smoke seal is used. Replacements must match. Swapping in a generic strip from a hardware shop can undermine the door's performance.
On a typical job that means:
- Removal of damaged or painted seals
- Identification of the specified seals
- Intumescent strips in frame or leaf edge
- Brush or blade smoke seals
What the rules say for Sandown
In Sandown, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.
Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Sandown building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.
Buildings and duty holders in Sandown
You are most likely to need intumescent strips and smoke seals if you look after care homes, blocks of flats or schools. Whatever the building in Sandown, we survey each opening and tell you which doors need work and which do not.
How a Sandown job runs
- Identify door certification and seal specification
- Remove failed seals and clean the grooves
- Fit new strips and seals to the specified positions
- Fit missing pads and lock linings
- Check the door closes and latches against the new seals
- Record the products fitted
Budgeting for intumescent strips and smoke seals in Sandown
Budget around £45–£110 per door to supply and fit strips and seals, ex VAT for intumescent strips and smoke seals. Our guide prices are the same in Sandown as elsewhere; what changes the cost is the doors themselves. Use our guide-price tool for a quick estimate.
Nearby areas we cover from Sandown
We also cover towns near Sandown, including Ryde (8.7 km away), Newport (Isle of Wight) and Cowes. If your building is in PO36 or a neighbouring district, the service and pricing are the same.
Questions from Sandown
Is Sandown within your coverage area?
It is. We cover Sandown in Isle of Wight and neighbouring towns such as Ryde. There is no charge for the survey.
Can you work from an existing inspection report for my Sandown building?
Yes. Send it over and we can often price straight from it, then confirm on site. We report back against the same door references so you can close actions off.
How long do seals last?
It depends on use and care. Seals on busy doors wear faster. Regular inspections will show when they need replacing.
Can I just add intumescent strips to an ordinary door?
No. Strips do not turn an ordinary door into a fire door. They only work as part of a door that was tested and certified with them.