Intumescent strips and smoke seals in Hawarden: what's involved
From the CH5 postcode district outwards, we take on intumescent strips and smoke seals across Hawarden for homes, blocks and workplaces.
Hawarden has a broad mix of buildings, including light industrial buildings, care homes and schools, and the same fire door principles apply to all of them.
We check that each door in your Hawarden building closes and latches against its new seals before signing it off. Painted and missing seals are among the most common fire door defects nationally; in Hawarden we replace them with the type and size the certification specifies.
Getting the specification right
The door's certification states the type, size and position of strips and seals: in the frame or the leaf edge, single or double, and whether a combined intumescent and smoke seal is used. Replacements must match. Swapping in a generic strip from a hardware shop can undermine the door's performance.
Each installation includes:
- Identification of the specified seals
- Removal of damaged or painted seals
- Brush or blade smoke seals
- Check of gaps and closing after fitting
Which fire door rules apply in Hawarden?
Hawarden is in Wales, where new and replacement fire doors are covered by the Building Regulations 2010 as applied in Wales, with the Welsh Approved Document B as guidance. The Regulatory Reform (Fire Safety) Order 2005 also applies, so responsible persons in workplaces and the common parts of blocks must keep fire doors maintained.
One difference from England: regulation 10 of the Fire Safety (England) Regulations 2022, with its quarterly and annual fire door checks, does not apply in Wales. Your fire risk assessment sets the checking regime instead, and we work to it.
Who needs intumescent strips and smoke seals in Hawarden?
The need for intumescent strips and smoke seals usually arises in HMOs or schools, and sometimes offices. Each has its own pressures, such as residents at home or a building that must stay open, so we plan the sequence of work in Hawarden to keep escape routes protected throughout.
How a Hawarden job runs
- Identify door certification and seal specification
- Remove failed seals and clean the grooves
- Fit new strips and seals to the specified positions
- Fit missing pads and lock linings
- Check the door closes and latches against the new seals
- Record the products fitted
Guide prices in Hawarden
If you need a budget figure first, the guide for intumescent strips and smoke seals is £45–£110 per door to supply and fit strips and seals, ex VAT. We firm that up after a survey, pricing each door separately so you can see where the money goes.
Covering Hawarden and nearby
Neighbouring towns such as Deeside, Buckley, Chester and Flint are covered too, so clients with several buildings can use one installer and one evidence format.
Common questions
Do you cover CH5 and nearby postcodes?
Yes. We cover Hawarden including CH5, and nearby towns such as Deeside and Buckley. The survey and written quote are free.
Can you work from an existing inspection report for my Hawarden building?
Yes. Send it over and we can often price straight from it, then confirm on site. We report back against the same door references so you can close actions off.
How long do seals last?
It depends on use and care. Seals on busy doors wear faster. Regular inspections will show when they need replacing.
Do all fire doors need smoke seals?
Only where the door is specified for smoke control, such as FD30S doors. Many doors on escape routes and flat entrances are specified this way.