Certified fire doorsets in Tewkesbury, done to the evidence
Our certified fire doorsets service in Tewkesbury is simple: a survey, a fixed quote, certified products and an installation finished to the manufacturer's evidence.
Around Tewkesbury, small blocks of flats, light industrial buildings and care homes all depend on fire doors that close, latch and seal. We survey each opening and tell you plainly which doors need work and which don't.
Doorsets suit refurbishment programmes in Tewkesbury, where several openings can be measured, ordered and fitted in one planned sequence. Pre-hung doorsets keep disruption down in occupied buildings in Tewkesbury, with less cutting and fewer return visits.
How is a doorset installed?
The opening is prepared to the size and tolerances in the manufacturer's instructions. The frame is fixed with the specified fixings at the specified centres, packed where needed, and checked for square, plumb and twist. The gap between frame and wall is then sealed with a material covered by the evidence, which BS 8214:2026 now describes in more detail. Finally the leaf is adjusted, the closer is set and the assembly is tested before the architraves go on.
On a typical job that means:
- Pre-hung, pre-machined doorsets where available
- Doorset selection to rating, size and use
- Certificate references and photo record per opening
- Installation to the manufacturer's instructions
What the rules say for Tewkesbury
Fire doors in Tewkesbury fall under English rules. New and replacement doors are covered by the Building Regulations 2010 and Approved Document B. In workplaces and the common parts of blocks, the Regulatory Reform (Fire Safety) Order 2005, as clarified by the Fire Safety Act 2021, puts the duty on the responsible person to keep fire doors suitable and maintained.
For residential buildings in Tewkesbury above 11 metres, regulation 10 of the Fire Safety (England) Regulations 2022 adds checks: communal fire doors at least every three months and best-endeavours checks of flat entrance doors at least every twelve months. Higher-risk buildings of at least 18 metres or seven storeys also come under the Building Safety Act 2022, where works may need approval from the Building Safety Regulator.
Where certified fire doorsets fit in Tewkesbury
Landlords, managing agents, facilities teams and homeowners in Tewkesbury can all commission certified fire doorsets from us. The usual settings are new-build and conversion projects and schools and offices, though single doors for blocks of flats are just as welcome.
Our process in Tewkesbury
- Survey and measure every structural opening
- Specify doorsets by rating, size, hand, finish and hardware
- Prepare openings and remove existing doors and linings
- Fix and seal the frames to the structure
- Hang, adjust and test each leaf and closer
- Fit architraves, make good and hand over evidence
What does certified fire doorsets cost in Tewkesbury?
Guide pricing for certified fire doorsets: £650–£1,300 for an FD30 doorset and £850–£1,800 for FD60, supplied and fitted, ex VAT. Volume work across several doors in one Tewkesbury building usually brings the per-door cost down. Your written quote is fixed once we have surveyed.
Tewkesbury and neighbouring towns
Tewkesbury is about 15.2 km from Gloucester, and we cover both, along with nearby Cheltenham and Great Malvern. Send us your postcode and we'll confirm survey dates.
Common questions
Do you work in Tewkesbury?
Yes, we take on certified fire doorsets in Tewkesbury and the surrounding area, including Cheltenham and Gloucester. Send your postcode and a few details and we'll come back with survey dates.
How quickly can you survey in Tewkesbury?
It depends on the number of doors and access, but we offer survey dates as soon as we reply to your enquiry. If an inspection has found urgent safety issues, tell us and we'll prioritise.
Are doorsets more expensive than a leaf?
The product costs more, but the labour is often lower and the result is better evidenced. Where a frame would need replacing anyway, a doorset is usually the better value.
Can a doorset be fitted into an existing opening?
Usually, yes. Doorsets are made to fit the structural opening once the old frame is removed. We measure the opening on the survey so the doorset is made to the right size and the gaps to the wall stay within what the evidence allows.