Fire door ironmongery for Burnham-on-Sea buildings
If you need fire door ironmongery in Burnham-on-Sea, we can survey, supply and install, then leave you the evidence your fire risk assessor will ask for.
Around Burnham-on-Sea, schools, family homes after loft conversions and houses with integral garages all depend on fire doors that close, latch and seal. We survey each opening and tell you plainly which doors need work and which don't.
Missing hinge screws and unsuitable locks are routine findings on fire door inspections everywhere; in Burnham-on-Sea we replace them with hardware covered by each door's evidence. Signage for fire doors in Burnham-on-Sea buildings is fitted as part of the job, not as an afterthought.
Common hardware defects
Inspections regularly find missing hinge screws, mismatched hinges, plastic-bodied latches, unapproved bolts and locks fitted without intumescent protection. We replace them with items covered by the door's evidence and fit the matching pads and linings.
What you get:
- Lever handles, pull handles and push plates
- Fire-rated hinges, commonly grade 13
- Bolts and selectors where specified
- Intumescent pads and lock linings
Which fire door rules apply in Burnham-on-Sea?
Fire doors in Burnham-on-Sea fall under English rules. New and replacement doors are covered by the Building Regulations 2010 and Approved Document B. In workplaces and the common parts of blocks, the Regulatory Reform (Fire Safety) Order 2005, as clarified by the Fire Safety Act 2021, puts the duty on the responsible person to keep fire doors suitable and maintained.
For residential buildings in Burnham-on-Sea above 11 metres, regulation 10 of the Fire Safety (England) Regulations 2022 adds checks: communal fire doors at least every three months and best-endeavours checks of flat entrance doors at least every twelve months. Higher-risk buildings of at least 18 metres or seven storeys also come under the Building Safety Act 2022, where works may need approval from the Building Safety Regulator.
Which buildings in Burnham-on-Sea need fire door ironmongery?
You are most likely to need fire door ironmongery if you look after offices, schools or HMOs. Whatever the building in Burnham-on-Sea, we survey each opening and tell you which doors need work and which do not.
From enquiry to handover in Burnham-on-Sea
- Identify the door's certification and hardware schedule
- List items that need replacing
- Supply matching hardware
- Fit with correct pads and linings
- Check operation, closing and latching
- Record what was fitted
What does fire door ironmongery cost in Burnham-on-Sea?
As a guide, budget from £40 for minor items to £350 for a full hardware set per door, ex VAT for fire door ironmongery. The figure for your Burnham-on-Sea building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.
Covering Burnham-on-Sea and nearby
We also cover towns near Burnham-on-Sea, including Weston-super-Mare (12.0 km away), Bridgwater and Clevedon. If your building is in TA8 or a neighbouring district, the service and pricing are the same.
Questions
Is Burnham-on-Sea within your coverage area?
It is. We cover Burnham-on-Sea in Somerset and neighbouring towns such as Weston-super-Mare. There is no charge for the survey.
Can you work from an existing inspection report for my Burnham-on-Sea building?
Yes. Send it over and we can often price straight from it, then confirm on site. We report back against the same door references so you can close actions off.
Can I fit a new lock to a fire door?
Only one that is covered by the door's test evidence, fitted with the correct intumescent protection. A larger lock body or new holes can compromise the door.
Do fire doors need signs?
Most fire doors in non-domestic buildings and common parts should carry signage showing whether they are to be kept shut, kept locked or are automatic.