FD60 fire doors in Gloucester

FD60 fire doors in Gloucester, done to the evidence

If you need FD60 fire doors in Gloucester, we can survey, supply and install, then leave you the evidence your fire risk assessor will ask for.

Around Gloucester, GP surgeries, purpose-built flats and industrial units all depend on fire doors that close, latch and seal. We survey each opening and tell you plainly which doors need work and which don't.

FD60 openings in Gloucester buildings tend to be stair cores, plant rooms and bin stores in larger blocks and commercial premises. Before ordering FD60 doors for a Gloucester building, we check the rating each opening actually needs, because over-specifying makes doors heavier and dearer.

Why FD60 installation is less forgiving

A 54mm leaf can weigh considerably more than a 44mm one. That weight drives everything else: more robust frames and fixings, hinges rated for the load, and a closer with enough power to close and latch the door without making it too heavy to open. Glazing, if any, must use a 60-minute glass and glazing system from the same test evidence.

Because of this, most FD60 openings are best done as a certified doorset, so the frame and leaf come with matching evidence.

Each installation includes:

• Check of the fire strategy rating for each opening
• 60-minute glazing systems where vision panels are needed
• Intumescent and smoke seals as specified
• Load-rated hinges and correctly powered closer

Which fire door rules apply in Gloucester?

Fire doors in Gloucester fall under English rules. New and replacement doors are covered by the Building Regulations 2010 and Approved Document B. In workplaces and the common parts of blocks, the Regulatory Reform (Fire Safety) Order 2005, as clarified by the Fire Safety Act 2021, puts the duty on the responsible person to keep fire doors suitable and maintained.

For residential buildings in Gloucester above 11 metres, regulation 10 of the Fire Safety (England) Regulations 2022 adds checks: communal fire doors at least every three months and best-endeavours checks of flat entrance doors at least every twelve months. Higher-risk buildings of at least 18 metres or seven storeys also come under the Building Safety Act 2022, where works may need approval from the Building Safety Regulator.

Who needs FD60 fire doors in Gloucester?

Typical settings for FD60 fire doors include refuse stores, mixed-use commercial buildings and plant and boiler rooms. In Gloucester, as anywhere, the duty holder varies: a responsible person for a workplace, a landlord or managing agent for a block or HMO, or a homeowner after building work. We adjust access, timing and paperwork to suit whoever commissions the work.

The steps on a Gloucester installation

1. Confirm the 60-minute requirement against the fire strategy
2. Survey structure, opening size and wall type
3. Order the certified doorset with ironmongery to its evidence
4. Install the frame, fix and seal it to the structure
5. Hang, adjust and test the leaf, closer and latching
6. Record evidence and make good

Budgeting for FD60 fire doors in Gloucester

As a guide, budget £850–£1,800 per FD60 doorset supplied and fitted, ex VAT for FD60 fire doors. The figure for your Gloucester building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.

Nearby areas we cover from Gloucester

Beyond Gloucester itself we also cover nearby towns such as Cheltenham (11.8 km), Stroud and Tewkesbury. The service, pricing and evidence are the same wherever you are.

Common questions