FD30 fire doors in Kingswood

FD30 fire doors in Kingswood, done to the evidence

When you book FD30 fire doors in Kingswood, the aim is simple: doors that close, latch and seal as tested, with records that prove it.

Buildings in and around Kingswood range from care homes to houses with integral garages and small offices. Whatever the building, the standard is the same: certified products, correct gaps, seals and closers, and a frame sealed to the wall.

Each FD30 leaf we supply for Kingswood is sized for the opening, rather than trimmed beyond what its certification allows. In Kingswood, FD30 doors are the usual choice for escape-route corridors, stairs and kitchen doors where the fire strategy asks for 30 minutes.

What does a correct FD30 installation include?

A typical timber FD30 leaf is around 44mm thick and hangs on at least three fire-tested hinges. The gaps between leaf and frame are set to the manufacturer's data, usually around 3mm. Intumescent strips, and smoke seals where needed, go in the frame or leaf edge as specified. The closer must pull the door shut and latch it from any angle. Every hole cut for a lock, latch or hinge is lined with intumescent material where the certification calls for it.

Then comes the part that is often skipped: sealing the gap between the frame and the wall with a tested material, as BS 8214:2026 now sets out in more detail.

As standard, the work covers:

• Fire-tested hinges, latch or lock and intumescent pads
• Photo record, product data and certificate references at handover
• Survey of the opening, frame and existing ironmongery
• Overhead closer set to close and latch

What the rules say for Kingswood

Fire doors in Kingswood fall under English rules. New and replacement doors are covered by the Building Regulations 2010 and Approved Document B. In workplaces and the common parts of blocks, the Regulatory Reform (Fire Safety) Order 2005, as clarified by the Fire Safety Act 2021, puts the duty on the responsible person to keep fire doors suitable and maintained.

For residential buildings in Kingswood above 11 metres, regulation 10 of the Fire Safety (England) Regulations 2022 adds checks: communal fire doors at least every three months and best-endeavours checks of flat entrance doors at least every twelve months. Higher-risk buildings of at least 18 metres or seven storeys also come under the Building Safety Act 2022, where works may need approval from the Building Safety Regulator.

Buildings and duty holders in Kingswood

Landlords, managing agents, facilities teams and homeowners in Kingswood can all commission FD30 fire doors from us. The usual settings are blocks of flats and shops, though single doors for schools are just as welcome.

Our process in Kingswood

1. Measure the opening, check the frame and confirm the rating needed
2. Order a certified leaf or doorset to size, with matching components
3. Remove the old door and assess the frame or structural opening
4. Fix the frame and hang the leaf to the certified gap tolerances
5. Fit seals, hinges, latch, closer and signage, then test close-and-latch
6. Seal the frame-to-wall gap, make good and record the evidence

Prices for FD30 fire doors in Kingswood

If you need a budget figure first, the guide for FD30 fire doors is £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT. We firm that up after a survey, pricing each door separately so you can see where the money goes.

Kingswood and neighbouring towns

Kingswood is about 49.4 km from Gloucester, and we cover both, along with nearby Mangotsfield and Bristol. Send us your postcode and we'll confirm survey dates.

Questions from Kingswood