FD30 fire doors: our service in Buckley
For property owners, landlords and managing agents in Buckley, we offer FD30 fire doors with one team for the survey, the product and the installation.
Buildings in and around Buckley range from low-rise blocks of flats to HMOs and schools. Whatever the building, the standard is the same: certified products, correct gaps, seals and closers, and a frame sealed to the wall.
In Buckley, FD30 doors are the usual choice for escape-route corridors, stairs and kitchen doors where the fire strategy asks for 30 minutes. Each FD30 leaf we supply for Buckley is sized for the opening, rather than trimmed beyond what its certification allows.
Leaf only or a full doorset?
If the existing frame is sound, correctly sized, securely fixed and compatible with the new leaf's certification, a new FD30 leaf can be hung in it. Many frames do not pass that test: old softwood linings, frames that have been cut about for previous doors, or frames with no evidence of how they were fixed. In those cases a certified doorset (leaf, frame and ironmongery tested together) is the cleaner answer and usually the quicker one on site.
We tell you which route each opening needs on the survey, door by door, and why.
What you get:
- Overhead closer set to close and latch
- Intumescent strips and smoke seals to the certification
- Fire-tested hinges, latch or lock and intumescent pads
- Certified FD30 or FD30S leaf, or full doorset
Which fire door rules apply in Buckley?
Buckley is in Wales, where new and replacement fire doors are covered by the Building Regulations 2010 as applied in Wales, with the Welsh Approved Document B as guidance. The Regulatory Reform (Fire Safety) Order 2005 also applies, so responsible persons in workplaces and the common parts of blocks must keep fire doors maintained.
One difference from England: regulation 10 of the Fire Safety (England) Regulations 2022, with its quarterly and annual fire door checks, does not apply in Wales. Your fire risk assessment sets the checking regime instead, and we work to it.
Buildings and duty holders in Buckley
Typical settings for FD30 fire doors include offices, HMOs and schools. In Buckley, as anywhere, the duty holder varies: a responsible person for a workplace, a landlord or managing agent for a block or HMO, or a homeowner after building work. We adjust access, timing and paperwork to suit whoever commissions the work.
The steps on a Buckley installation
- Measure the opening, check the frame and confirm the rating needed
- Order a certified leaf or doorset to size, with matching components
- Remove the old door and assess the frame or structural opening
- Fix the frame and hang the leaf to the certified gap tolerances
- Fit seals, hinges, latch, closer and signage, then test close-and-latch
- Seal the frame-to-wall gap, make good and record the evidence
Prices for FD30 fire doors in Buckley
As a guide, budget £300–£600 for a leaf into a sound existing frame; £650–£1,300 for a doorset, ex VAT for FD30 fire doors. The figure for your Buckley building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.
Nearby areas we cover from Buckley
Buckley is about 14.7 km from Wrexham, and we cover both, along with nearby Hawarden and Deeside. Send us your postcode and we'll confirm survey dates.
Questions
Do you work in Buckley?
Yes, we take on FD30 fire doors in Buckley and the surrounding area, including Hawarden and Deeside. Send your postcode and a few details and we'll come back with survey dates.
Can you work from an existing inspection report for my Buckley building?
Yes. Send it over and we can often price straight from it, then confirm on site. We report back against the same door references so you can close actions off.
How long does it take to fit an FD30 door?
A leaf into a sound frame is often a few hours. A full doorset including frame removal, fixing, sealing and making good is usually half a day to a day per opening, depending on access and the wall construction.
What is the difference between FD30 and FD30S?
FD30S has been tested for smoke control as well as fire. It adds a smoke seal, usually a brush or blade, and needs a tight threshold gap. Flat entrance doors and doors onto protected escape routes are commonly specified as FD30S.