What double fire doors in Ramsgate should include
When you book double fire doors in Ramsgate, the aim is simple: doors that close, latch and seal as tested, with records that prove it.
In and around Ramsgate, fire door work covers everything from schools to small blocks of flats. We plan each job around the people who use the building.
Double doors on wards, school corridors and lobbies in Ramsgate take heavy use, so closing sequence and meeting-edge seals get extra attention. Every pair we fit in Ramsgate is commissioned so both leaves close in the right order and latch.
Hold-opens and escape
Pairs on corridors are often held open in daily use, with hold-open devices releasing both leaves when the alarm sounds. Where a pair is on an escape route used by the public, the escape hardware and the direction of opening also need to suit the fire strategy.
Each installation includes:
- Meeting-stile intumescent and smoke seals
- Equal pair or leaf-and-a-half doorsets
- Commissioning of closing sequence
- Closers matched to each leaf
Rules and responsibilities in Ramsgate
In Ramsgate, as elsewhere in England, the starting point is the Fire Safety Order 2005: whoever controls a workplace or the shared parts of a residential block must make sure its fire doors work. When doors are replaced, the Building Regulations and Approved Document B set the standard the new work has to meet.
Blocks above 11 metres have a specific routine under regulation 10 of the Fire Safety (England) Regulations 2022: quarterly checks of communal fire doors and annual best-endeavours checks of flat front doors. If your Ramsgate building is a higher-risk building under the Building Safety Act 2022, we confirm the approval route with the Principal Accountable Person before any work is ordered.
Where double fire doors fit in Ramsgate
The need for double fire doors usually arises in hospitals and clinics or communal corridors, and sometimes office cores. Each has its own pressures, such as residents at home or a building that must stay open, so we plan the sequence of work in Ramsgate to keep escape routes protected throughout.
How a Ramsgate job runs
- Survey opening width, use and traffic
- Select pair configuration and hardware set
- Order certified doorset with coordinator and bolts if needed
- Install frame and hang both leaves
- Set closing sequence, seals and latching
- Test hold-open release and record evidence
Guide prices in Ramsgate
As a guide, budget £1,600–£3,400 per pair supplied and fitted, depending on glazing and hardware, ex VAT for double fire doors. The figure for your Ramsgate building depends on the number of doors, the rating, the condition of the frames, finishes, hardware and access. We confirm a fixed price after the free survey.
Nearby areas we cover from Ramsgate
Nearby towns we cover include Broadstairs, Margate and Deal. Distance from Ramsgate does not change our guide prices, and the survey and quote are free.
Questions
Is Ramsgate within your coverage area?
It is. We cover Ramsgate in Kent and neighbouring towns such as Broadstairs. There is no charge for the survey.
Can you work from an existing inspection report for my Ramsgate building?
Yes. Send it over and we can often price straight from it, then confirm on site. We report back against the same door references so you can close actions off.
What does a door coordinator do?
It holds the leaf that must close second until the first leaf has shut, so rebated meeting edges close in the right order and both leaves latch. Without it, the pair can end up open or misaligned.
Why does the gap between the two leaves matter?
The meeting edges are where flame and smoke can pass most easily. The gap and the seals there must match the certification for the pair to perform as tested.